
Corona, CA: Chimney Work From the Roof and the Firebox
Ask Us to Look at Your Corona Chimney
Send your name, number and street. One of us calls back to set a Corona day for the roof and the firebox.
Corona ZIP Codes on Our Route
We book Corona on the same days as Jurupa Valley and Norco. Give us your street and we will say which day fits.
What We Do in Corona
Corona homes tend to need cap fastening, chase covers, gas unit checks and metal flue inspections. Cards below lead to the Corona page for that job.
Chimney Sweep in Corona
Creosote and soot out of the flue, with one brother on the roof checking the cap while the other works the firebox.
Learn MoreChimney Inspection in Corona
Level 1, 2 or 3 to NFPA 211, with photos from the roof and the firebox in one written report.
Learn MoreChimney Repair in Corona
Crown, mortar, liner and crack repair. On the coast we look at salt damage first, in the canyons at quake cracks.
Learn MoreFireplace Inspection in Corona
Firebox, refractory panels, damper and smoke chamber, checked before the first fire of the season.
Learn MoreFireplace Repair in Corona
Refractory, damper and hearth repairs, done in the order the inspection found them.
Learn MoreChimney Level 2 Inspection in Corona
The camera inspection for a sale, or after a quake or a fire season. We send the report to you and your agent.
Learn MoreChimney Cap Installation in Corona
Stainless or copper caps with spark arrestor mesh, sized on the roof. The part salt air and embers test first.
Learn MoreChimney Flashing Repair in Corona
Step and counter flashing where the chimney meets the roof, sealed before the winter rain.
Learn MoreChimney Masonry Repair in Corona
Tuckpointing and brick work on stacks that face the ocean or sit on a canyon slope.
Learn MoreChimney Rebuilds in Corona
Partial or full rebuilds when repairs will not hold, from the roofline up or from the firebox.
Learn MoreFireplace Cleaning in Corona
Firebox, glass doors and hearth cleaned out, for wood, gas and electric units.
Learn MoreGas Fireplace Cleaning in Corona
Burner, pilot, logs and glass serviced once a year. Beach air coats a gas unit faster than people think.
Learn MoreGas Fireplace Repair in Corona
Pilot, thermocouple, valve and ignition faults traced on site and fixed.
Learn MoreFireplace Remodel in Corona
New surrounds, mantels and insert conversions, after we check the firebox and flue underneath.
Learn MoreFireplace Inserts in Corona
Gas, wood or electric inserts fitted to the firebox, with the liner and venting sized for it.
Learn MorePellet Stove Repair in Corona
Auger, igniter, blower and control board work for stoves in the canyons and up the coast.
Learn MoreWood Stove Repair in Corona
Baffles, firebrick, gaskets and combustors for the canyon homes that heat with wood.
Learn MoreGas Logs in Corona
Vented or ventless log sets sized to the room, with the gas line and a damper clamp.
Learn MoreWhat the two of us look for in Corona
About 3 in 4 homes here postdate 1980, so most Corona fireplaces are factory-built metal or gas, while some older homes keep masonry. Hillside custom houses in the national forest foothills are the exception, and those have their own wind and fire questions. Fall and winter gusts can strip a cap outright and spread embers, particularly near the foothills. In the Temescal Valley nearby, a section of the Elsinore fault zone runs right under the neighborhoods.
On the Roof
Strong wind is the local problem, so we test every cap and check that chase covers still sit tight.
At the Firebox
Metal flues get read at each section, with any older masonry getting a camera pass for fault damage.
When to Call
Before Santa Ana season, or before the rain if you notice rust on a chase cover.
The Houses
In Corona: newer tract homes with factory-built or gas fireplaces, hillside custom homes and some older masonry.
Corona Visits
Get both ends of your Corona chimney checked
One call sets the day. One of us takes the roof, the other takes the firebox, and the report with photos from both comes with the visit.
